Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
breakout [2022/03/25 15:06] beckmanf [Deskproto] |
breakout [2022/03/26 17:35] beckmanf [Deskproto] |
||
|---|---|---|---|
| Line 512: | Line 512: | ||
| ==== Deskproto ==== | ==== Deskproto ==== | ||
| - | The Deskproto CAM software is installed and can be started with the GUI. Please check start the graphical desktop manager via TurboVNC as described in the [[https://www.hs-augsburg.de/homes/beckmanf/dokuwiki/doku.php?id=breakout#virtualgl_und_turbovnc|TurboVNC chapter]]. | + | The Deskproto CAM software [[sw-milling|for milling]] is installed and can be started with the GUI. Please check start the graphical desktop manager via TurboVNC as described in the [[breakout#virtualgl_und_turbovnc|TurboVNC chapter]]. |
| === First Time Setup === | === First Time Setup === | ||
| Line 534: | Line 534: | ||
| <code> | <code> | ||
| cd | cd | ||
| - | cp /opt/deskproto/Deskproto.conf ~/.config/'Delft Spline Systems' | + | cp /opt/deskproto/DeskProto.conf ~/.config/'Delft Spline Systems' |
| </code> | </code> | ||