Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
dt_openocd [2014/02/16 22:25] yusa |
dt_openocd [2014/06/27 09:35] (current) beckmanf added flyswatter usb configuration |
||
---|---|---|---|
Line 20: | Line 20: | ||
<code> | <code> | ||
git clone git://git.code.sf.net/p/openocd/code openocd-code | git clone git://git.code.sf.net/p/openocd/code openocd-code | ||
+ | </code> | ||
+ | |||
+ | Install the libusb-1.0 package | ||
+ | |||
+ | <code> | ||
+ | sudo apt-get install libusb-1.0-0-dev | ||
+ | ./bootstrap | ||
+ | ./configure --prefix=$HOME/site | ||
+ | make | ||
+ | make install | ||
+ | </code> | ||
+ | |||
+ | Add the file /etc/udev/rules.d/52-flyswatter.rules. This will make the usb device accessible without root permissions. | ||
+ | |||
+ | <code> | ||
+ | # Flyswatter JTAG Debugger | ||
+ | SUBSYSTEMS=="usb", ATTR{idVendor}=="0403", ATTR{idProduct}=="6010", MODE="0666" | ||
</code> | </code> | ||
Line 209: | Line 226: | ||
(gdb) print [var] | (gdb) print [var] | ||
</code> | </code> | ||
- | |||