Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
searchwing-wing-servo [2020/02/02 13:55] beckmanf [Wing servo connection] schrumpfschlauch 1,2 -> 1,6 |
searchwing-wing-servo [2020/02/03 18:52] (current) beckmanf Shorten cable, reduce transparent shrinking tube to 20mm |
||
---|---|---|---|
Line 22: | Line 22: | ||
{{:sw-servo-m5-to-pixracer.jpg?600|Solder view}} | {{:sw-servo-m5-to-pixracer.jpg?600|Solder view}} | ||
- | * Cut 25mm of the transparent shrinking tube and put it on the cable | + | * Shorten the servo cable by 40mm |
+ | * Cut 20mm of the transparent shrinking tube and put it on the cable | ||
* Separate the yellow, red and brown cable for about 5cm | * Separate the yellow, red and brown cable for about 5cm | ||
- | * Add about 5mm of the 1.2mm shrinking tube to the red and the brown cable. | + | * Add about 5mm of the small shrinking tube to the red and the brown cable. |
* Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking | * Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking | ||
* Remove the isolation for about 4mm and twist and tin the wires. | * Remove the isolation for about 4mm and twist and tin the wires. | ||
Line 48: | Line 49: | ||
The next image shows the small shrinking tubes moved over the solder connections. | The next image shows the small shrinking tubes moved over the solder connections. | ||
- | {{:sw-m5-shrinking-tube.jpg?600|Socket with 1.2mm shrinking tubes}} | + | {{:sw-m5-shrinking-tube.jpg?600|Socket with shrinking tubes}} |
* Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed. | * Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed. |