Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
searchwing-ardupilot-parameters [2020/02/27 11:23] beckmanf [Tuning] |
searchwing-ardupilot-parameters [2020/02/28 08:02] beckmanf compass, mixing gain |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Ardupilot Parameter Setup ====== | ====== Ardupilot Parameter Setup ====== | ||
- | [[https://ardupilot.org/plane/docs/parameters-Plane-stable-V4.0.3.html|Description of the parameters]] | + | [[https://ardupilot.org/plane/docs/parameters-Plane-stable-V4.0.3.html|Ardupilot description of the parameters]] |
+ | |||
+ | [[https://gitlab.com/searchwing/operational/searchwing-config/-/tree/master/ardupilot%2Fv4.0.3|Kurdi Settings on gitlab]] | ||
==== Arming / Safety ==== | ==== Arming / Safety ==== | ||
Line 11: | Line 13: | ||
|INS_GYRO_CAL |0 |Disable Gyro Calibration at startup | This prevents INS calibration at startup| | |INS_GYRO_CAL |0 |Disable Gyro Calibration at startup | This prevents INS calibration at startup| | ||
|ARSPD_TYPE |0 |No Airspeed Pitot Tube | Disable the Pitottube airspeed sensor (we don't have one)| | |ARSPD_TYPE |0 |No Airspeed Pitot Tube | Disable the Pitottube airspeed sensor (we don't have one)| | ||
+ | |COMPASS_USE2 |0 |Disable PixRacer compass | Disable the PixRacer internal compass | | ||
+ | |COMPASS_USE3 |0 |Disable PixRacer compass | Disable the PixRacer internal compass | | ||
Is the safety_mask maybe not required because the pixracer is always in safe state? Safe and disarmed is different? | Is the safety_mask maybe not required because the pixracer is always in safe state? Safe and disarmed is different? | ||
Line 39: | Line 42: | ||
^Parametername ^Value ^Description ^Remark ^ | ^Parametername ^Value ^Description ^Remark ^ | ||
- | |MIXING_GAIN |1.0 |Mixing of pitch and rudder to vtail |Default is 0.5 - full pitch will yield only 50 percent of vtail servo output | | + | |MIXING_GAIN |0.75 |Mixing of pitch and rudder to vtail |Default is 0.5 - full pitch will yield only 50 percent of vtail servo output | |
Line 73: | Line 76: | ||
1 1 BATT_MONITOR 4 2 | 1 1 BATT_MONITOR 4 2 | ||
1 1 BATT_SERIAL_NUM -1 6 | 1 1 BATT_SERIAL_NUM -1 6 | ||
- | 1 1 BATT_VOLT_MULT 10.13 9 | + | 1 1 BATT_VOLT_MULT 10.213 9 |
1 1 BATT_VOLT_PIN 2 2 | 1 1 BATT_VOLT_PIN 2 2 | ||
1 1 BATT_WATT_MAX 0 4 | 1 1 BATT_WATT_MAX 0 4 |