Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
searchwing-pi-camera [2020/02/15 17:49] beckmanf y-cable again |
searchwing-pi-camera [2020/02/17 12:47] j0ge4622 |
||
---|---|---|---|
Line 35: | Line 35: | ||
Now the power connections from the PowerModule are left. | Now the power connections from the PowerModule are left. | ||
- | * Take two 6-inch JST-GH cables and remove one connector. | + | * Take two 6-inch JST-GH cables and remove the connector at one side |
+ | * Crimp the Harwin M20 connector at that side | ||
+ | * Insert the JST-GH Cables in pin 1 and 3 of the JST-GH 4 pin power connector | ||
+ | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
+ | To mark the cables use colored heating tube. | ||
+ | |||
+ | {{ ::pizerow-pinlayout.png?direct |}} |