Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
searchwing-pi-datarate [2021/11/17 22:34] wf68spef |
searchwing-pi-datarate [2021/11/17 22:35] wf68spef |
||
---|---|---|---|
Line 545: | Line 545: | ||
channel 64 (5320 MHz), width: 80 MHz, center1: 5290 MHz | channel 64 (5320 MHz), width: 80 MHz, center1: 5290 MHz | ||
txpower 31.00 dBm | txpower 31.00 dBm | ||
- | |||
- | pi@testi:~ $ iw phy | ||
- | Wiphy phy0 | ||
- | max # scan SSIDs: 10 | ||
- | max scan IEs length: 2048 bytes | ||
- | max # sched scan SSIDs: 16 | ||
- | max # match sets: 16 | ||
- | Retry short limit: 7 | ||
- | Retry long limit: 4 | ||
- | Coverage class: 0 (up to 0m) | ||
- | Device supports roaming. | ||
- | Device supports T-DLS. | ||
- | Supported Ciphers: | ||
- | * WEP40 (00-0f-ac:1) | ||
- | * WEP104 (00-0f-ac:5) | ||
- | * TKIP (00-0f-ac:2) | ||
- | * CCMP-128 (00-0f-ac:4) | ||
- | * CMAC (00-0f-ac:6) | ||
- | Available Antennas: TX 0 RX 0 | ||
- | Supported interface modes: | ||
- | * IBSS | ||
- | * managed | ||
- | * AP | ||
- | * P2P-client | ||
- | * P2P-GO | ||
- | * P2P-device | ||
- | Band 1: | ||
- | Capabilities: 0x1020 | ||
- | HT20 | ||
- | Static SM Power Save | ||
- | RX HT20 SGI | ||
- | No RX STBC | ||
- | Max AMSDU length: 3839 bytes | ||
- | DSSS/CCK HT40 | ||
- | Maximum RX AMPDU length 65535 bytes (exponent: 0x003) | ||
- | Minimum RX AMPDU time spacing: 16 usec (0x07) | ||
- | HT TX/RX MCS rate indexes supported: 0-7 | ||
- | Bitrates (non-HT): | ||
- | * 1.0 Mbps | ||
- | * 2.0 Mbps (short preamble supported) | ||
- | * 5.5 Mbps (short preamble supported) | ||
- | * 11.0 Mbps (short preamble supported) | ||
- | * 6.0 Mbps | ||
- | * 9.0 Mbps | ||
- | * 12.0 Mbps | ||
- | * 18.0 Mbps | ||
- | * 24.0 Mbps | ||
- | * 36.0 Mbps | ||
- | * 48.0 Mbps | ||
- | * 54.0 Mbps | ||
- | Frequencies: | ||
- | * 2412 MHz [1] (20.0 dBm) | ||
- | * 2417 MHz [2] (20.0 dBm) | ||
- | * 2422 MHz [3] (20.0 dBm) | ||
- | * 2427 MHz [4] (20.0 dBm) | ||
- | * 2432 MHz [5] (20.0 dBm) | ||
- | * 2437 MHz [6] (20.0 dBm) | ||
- | * 2442 MHz [7] (20.0 dBm) | ||
- | * 2447 MHz [8] (20.0 dBm) | ||
- | * 2452 MHz [9] (20.0 dBm) | ||
- | * 2457 MHz [10] (20.0 dBm) | ||
- | * 2462 MHz [11] (20.0 dBm) | ||
- | * 2467 MHz [12] (20.0 dBm) | ||
- | * 2472 MHz [13] (20.0 dBm) | ||
- | * 2484 MHz [14] (disabled) | ||
- | Band 2: | ||
- | Capabilities: 0x1062 | ||
- | HT20/HT40 | ||
- | Static SM Power Save | ||
- | RX HT20 SGI | ||
- | RX HT40 SGI | ||
- | No RX STBC | ||
- | Max AMSDU length: 3839 bytes | ||
- | DSSS/CCK HT40 | ||
- | Maximum RX AMPDU length 65535 bytes (exponent: 0x003) | ||
- | Minimum RX AMPDU time spacing: 16 usec (0x07) | ||
- | HT TX/RX MCS rate indexes supported: 0-7 | ||
- | VHT Capabilities (0x00001020): | ||
- | Max MPDU length: 3895 | ||
- | Supported Channel Width: neither 160 nor 80+80 | ||
- | short GI (80 MHz) | ||
- | SU Beamformee | ||
- | VHT RX MCS set: | ||
- | 1 streams: MCS 0-9 | ||
- | 2 streams: not supported | ||
- | 3 streams: not supported | ||
- | 4 streams: not supported | ||
- | 5 streams: not supported | ||
- | 6 streams: not supported | ||
- | 7 streams: not supported | ||
- | 8 streams: not supported | ||
- | VHT RX highest supported: 0 Mbps | ||
- | VHT TX MCS set: | ||
- | 1 streams: MCS 0-9 | ||
- | 2 streams: not supported | ||
- | 3 streams: not supported | ||
- | 4 streams: not supported | ||
- | 5 streams: not supported | ||
- | 6 streams: not supported | ||
- | 7 streams: not supported | ||
- | 8 streams: not supported | ||
- | VHT TX highest supported: 0 Mbps | ||
- | Bitrates (non-HT): | ||
- | * 6.0 Mbps | ||
- | * 9.0 Mbps | ||
- | * 12.0 Mbps | ||
- | * 18.0 Mbps | ||
- | * 24.0 Mbps | ||
- | * 36.0 Mbps | ||
- | * 48.0 Mbps | ||
- | * 54.0 Mbps | ||
- | Frequencies: | ||
- | * 5170 MHz [34] (disabled) | ||
- | * 5180 MHz [36] (20.0 dBm) | ||
- | * 5190 MHz [38] (disabled) | ||
- | * 5200 MHz [40] (20.0 dBm) | ||
- | * 5210 MHz [42] (disabled) | ||
- | * 5220 MHz [44] (20.0 dBm) | ||
- | * 5230 MHz [46] (disabled) | ||
- | * 5240 MHz [48] (20.0 dBm) | ||
- | * 5260 MHz [52] (20.0 dBm) (no IR, radar detection) | ||
- | * 5280 MHz [56] (20.0 dBm) (no IR, radar detection) | ||
- | * 5300 MHz [60] (20.0 dBm) (no IR, radar detection) | ||
- | * 5320 MHz [64] (20.0 dBm) (no IR, radar detection) | ||
- | * 5500 MHz [100] (20.0 dBm) (no IR, radar detection) | ||
- | * 5520 MHz [104] (20.0 dBm) (no IR, radar detection) | ||
- | * 5540 MHz [108] (20.0 dBm) (no IR, radar detection) | ||
- | * 5560 MHz [112] (20.0 dBm) (no IR, radar detection) | ||
- | * 5580 MHz [116] (20.0 dBm) (no IR, radar detection) | ||
- | * 5600 MHz [120] (20.0 dBm) (no IR, radar detection) | ||
- | * 5620 MHz [124] (20.0 dBm) (no IR, radar detection) | ||
- | * 5640 MHz [128] (20.0 dBm) (no IR, radar detection) | ||
- | * 5660 MHz [132] (20.0 dBm) (no IR, radar detection) | ||
- | * 5680 MHz [136] (20.0 dBm) (no IR, radar detection) | ||
- | * 5700 MHz [140] (20.0 dBm) (no IR, radar detection) | ||
- | * 5720 MHz [144] (disabled) | ||
- | * 5745 MHz [149] (disabled) | ||
- | * 5765 MHz [153] (disabled) | ||
- | * 5785 MHz [157] (disabled) | ||
- | * 5805 MHz [161] (disabled) | ||
- | * 5825 MHz [165] (disabled) | ||
- | Supported commands: | ||
- | * new_interface | ||
- | * set_interface | ||
- | * new_key | ||
- | * start_ap | ||
- | * join_ibss | ||
- | * set_pmksa | ||
- | * del_pmksa | ||
- | * flush_pmksa | ||
- | * remain_on_channel | ||
- | * frame | ||
- | * set_wiphy_netns | ||
- | * set_channel | ||
- | * tdls_oper | ||
- | * start_sched_scan | ||
- | * start_p2p_device | ||
- | * connect | ||
- | * disconnect | ||
- | * crit_protocol_start | ||
- | * crit_protocol_stop | ||
- | * update_connect_params | ||
- | software interface modes (can always be added): | ||
- | valid interface combinations: | ||
- | * #{ managed } <= 1, #{ P2P-device } <= 1, #{ P2P-client, P2P-GO } <= 1, | ||
- | total <= 3, #channels <= 2 | ||
- | * #{ managed } <= 1, #{ AP } <= 1, #{ P2P-client } <= 1, #{ P2P-device } <= 1, | ||
- | total <= 4, #channels <= 1 | ||
- | Device supports scan flush. | ||
- | Device supports randomizing MAC-addr in sched scans. | ||
- | max # scan plans: 1 | ||
- | max scan plan interval: 508 | ||
- | max scan plan iterations: 0 | ||
- | Supported TX frame types: | ||
- | * managed: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 | ||
- | * AP: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 | ||
- | * P2P-client: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 | ||
- | * P2P-GO: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 | ||
- | * P2P-device: 0x00 0x10 0x20 0x30 0x40 0x50 0x60 0x70 0x80 0x90 0xa0 0xb0 0xc0 0xd0 0xe0 0xf0 | ||
- | Supported RX frame types: | ||
- | * managed: 0x40 0xd0 | ||
- | * AP: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 | ||
- | * P2P-client: 0x40 0xd0 | ||
- | * P2P-GO: 0x00 0x20 0x40 0xa0 0xb0 0xc0 0xd0 | ||
- | * P2P-device: 0x40 0xd0 | ||
- | Supported extended features: | ||
- | * [ 4WAY_HANDSHAKE_STA_PSK ]: 4-way handshake with PSK in station mode | ||
- | * [ 4WAY_HANDSHAKE_STA_1X ]: 4-way handshake with 802.1X in station mode | ||
- | * [ DFS_OFFLOAD ]: DFS offload | ||
</code> | </code> | ||