Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
flash_prepare_pi_zero_image [2021/06/16 13:38] wf68spef |
flash_prepare_pi_zero_image [2021/06/16 13:54] wf68spef |
||
|---|---|---|---|
| Line 19: | Line 19: | ||
| * Afterwards filesystem resize the camera-capture & webserver service is started | * Afterwards filesystem resize the camera-capture & webserver service is started | ||
| * You can access each camera via its hostname: ''ssh searchwing@freddy-l.local'' | * You can access each camera via its hostname: ''ssh searchwing@freddy-l.local'' | ||
| + | * Check proper system function | ||
| + | * Check output of image payload: ''journalctl -f -u searchwing-payloads-camera.service'' | ||
| + | * Check output of dht22 payload: ''journalctl -f -u searchwing-payloads-temp-humid.service'' | ||
| * The recorded images can be checked via webserver in the webbrowser using a laptop in the same WLAN : e.g. ''http:\\freddy-l.local'' | * The recorded images can be checked via webserver in the webbrowser using a laptop in the same WLAN : e.g. ''http:\\freddy-l.local'' | ||
| * Most recent image is saved in ''0_latest.jpg@'' | * Most recent image is saved in ''0_latest.jpg@'' | ||
| Line 25: | Line 28: | ||
| * can be done with the searchwing-pi-manager on the laptop | * can be done with the searchwing-pi-manager on the laptop | ||
| * is sent via Mavlink to QGC for the UART TX RX connected Pi zero | * is sent via Mavlink to QGC for the UART TX RX connected Pi zero | ||
| - | * Check proper system function | + | |
| - | * Login to drone via SSH | + | |
| - | * Check output of image payload: ''journalctl -f -u searchwing-payloads-camera.service'' | + | |