Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
searchwing-ardupilot-firmware [2019/10/01 18:10] beckmanf [Parameters] geofence |
searchwing-ardupilot-firmware [2019/10/01 18:15] beckmanf [Firmware installation] rc servo setup |
||
|---|---|---|---|
| Line 7: | Line 7: | ||
| The firmware is installed on the PixRacer via the QGroundControl Software. [[https://docs.qgroundcontrol.com/en/SetupView/Firmware.html|https://docs.qgroundcontrol.com/en/SetupView/Firmware.html]]\\ | The firmware is installed on the PixRacer via the QGroundControl Software. [[https://docs.qgroundcontrol.com/en/SetupView/Firmware.html|https://docs.qgroundcontrol.com/en/SetupView/Firmware.html]]\\ | ||
| Select "ChibiOs - ArduPlane V3.9.8" from drpdown. | Select "ChibiOs - ArduPlane V3.9.8" from drpdown. | ||
| + | |||
| + | === RC and Servo Setup === | ||
| + | |||
| + | Ardupilot hast just recently added new way which allows to configure the RC channel and the servo behaviour independently. QGC has not included this yet in the RC calibration procedure. Therefore **you have to check the correct servo behavior for RC and autopilot, e.g. BOTH!!!** It is possible that RC works in the right direction but autopilot steers in the opposite direction. This was the reason for the first Ardupilot flight crash. | ||
| ==== Mag Sensor Setup ==== | ==== Mag Sensor Setup ==== | ||