Differences
This shows you the differences between two versions of the page.
searchwing-inner-frame [2020/02/12 13:11] beckmanf created |
searchwing-inner-frame [2020/02/12 14:06] (current) beckmanf pla image |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== Inner Frame ===== | ===== Inner Frame ===== | ||
- | |||
- | {{::sw-frame-with-beams.jpg?600|SearchWing inner frame with beams - without tubes}} | ||
Author: Friedrich Beckmann | Author: Friedrich Beckmann | ||
+ | |||
+ | The following image shows the inner frame with beams, without PVC tubes, pixracerplate and gpsplate. | ||
+ | |||
+ | {{::sw-frame-with-beams.jpg?600|SearchWing inner frame with beams - without tubes}} | ||
The inner frame is 3D printed. | The inner frame is 3D printed. | ||
Line 17: | Line 19: | ||
* gpsplate | * gpsplate | ||
- | The 3D Print for the walls is done with Ultimaker 3 with "Normal" default print settings plus 2mm wall width. The plates are printed with "Normal" Settings with the Ultimaker 2+. After the print: | + | The 3D Print for the walls is done with Ultimaker 3 with "Normal" default print settings plus 2mm wall width. The plates are printed with "Normal" Settings with the Ultimaker 2+. Both use default PLA material. After the print: |
* Remove the support brim by hand | * Remove the support brim by hand |