Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
searchwing-pi-camera [2020/02/17 17:34] j0ge4622 |
searchwing-pi-camera [2020/02/17 17:35] j0ge4622 |
||
---|---|---|---|
Line 32: | Line 32: | ||
* Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | * Take an 8-inch JST-GH cable and remove the connector at one side. Remove 5mm of the isolation at the other. | ||
* Put this cable in the JST-GH connector at the location marked "TX". This is the UART RX port of the PixRacer. | * Put this cable in the JST-GH connector at the location marked "TX". This is the UART RX port of the PixRacer. | ||
- | {{ :pixacer-pinlayout_telem1.jpg?direct&600 |}} | + | {{ :pixacer-pinlayout_telem1.jpg?direct&400 |}} |
Now the power connections from the PowerModule are left. | Now the power connections from the PowerModule are left. |