This is an old revision of the document!
Raspberry Pi and Camera
We use the Raspberry Pi Zero W with the Raspberry Camera v2. The camera is mounted in the Camera Pipe.
Camera in Pipe
- Seal the camera with Elastosil. Use the pink dispenser needle with 0.58mm diameter
- Add the 15cm Pi Zero camera cable
- Fix the camera cable connector with hotmelt
- Fix the camera with the four 1,7 x 4mm screws
Raspberry UART Cable
The Raspberry 40 pin header must be connected to the PixRacer Telem2 and the power supply from the power module.