[[searchwing-pi-datarate]]

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
searchwing-pi-datarate [2020/01/08 21:38]
beckmanf [http transfer time for wifi] rate computed
searchwing-pi-datarate [2020/01/08 22:00]
beckmanf [Results]
Line 493: Line 493:
   * Placement: Pi Zero and Laptop placed 10cm above router.   * Placement: Pi Zero and Laptop placed 10cm above router.
   * data ammount: 540 MByte   * data ammount: 540 MByte
 +  * ** Laptop and Raspberry Pi share the same Wifi channel => Each packet goes from Pi to AP and from AP to Laptop. => Congestion on the Wifi Channel. **
  
 === wget === === wget ===
Line 506: Line 507:
 ==== Results ==== ==== Results ====
  
 +  * The Laptop and the Pi should not be connected via a single 2.4 GHz access point as laptop and Pi share the same Wifi channel. This results in 50% throughput reduction (see Julians 2.5 MB/s for wget).
 +  * The transfer rate via wget on an undisturbed 2.4 GHz wifi channel is **5 MB/s**. (Only Pi connected to AP, No other stations use this channel). This 40 MBit/s throughput on http level compares well to the maximum 65 MBit/s wifi data rate of the Pi Zero W.
 +  * ssh transfer is limited by CPU load on the Pi for encryption and results in 1.8 MB/s for Wifi.
 +  * Short Guard Interval setting could possibly increase the the raw wifi rate from 65 MBit/s to 72 MBit/​s. ​
  
  
  • searchwing-pi-datarate.txt
  • Last modified: 2021/11/18 15:08
  • by wf68spef