Differences

This shows you the differences between two versions of the page.

--- searchwing-rfd868-mount [2020/02/16 12:06]
beckmanf created
+++ searchwing-rfd868-mount [2020/02/17 12:40]
j0ge4622
@@ Line 1: / Line 1: @@
 ===== RFD 868+ telemetry radio mount =====
+Author: Friedrich Beckmann
 The modem is connected to the PixRacer Telem2 port and the power module. The modem is mounted in the right fuselage half and will be connected just shortly before glueing the two fuselage parts to the PixRacer and the Powermodule.
@@ Line 17: / Line 19: @@
 {{::sw-rfd868-connections.jpg?600|}}
-Fill all open places with empty Harwin M20 connector to increase the holding force of the connector.
+Remove Pin 15 of the RFD868+ modem. This will be the safety pin to avoid wrong mounting of the connector.
+{{::sw-rfd868-modem-safety-pin.jpg?600|}}
-Mark the RX and TX cables and then weave the cables such that they be closer together. Now take a JST-GH 6-Pin connector and insert the pins according to this image
+Solder the pin in a Harwin M20 connector and insert that connector in the Harwin housing. Fill the other four open places with empty Harwin M20 connector to increase the holding force of the connector.
+Mark the RX and TX and GND cables and then weave the cables such that they are closer together. Now take a JST-GH 6-Pin connector and insert the pins according to this image
 {{::sw-telem-uart.jpg?600|}}
+Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]]
+Please note the different directions of the connector/cables in the labeling.
+Pin layout of the Pixracer
+{{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 |}}
+Pin layout to the RFD868+
+{{ :pixacer-pinlayout_telem1.jpg?direct&400 |}}
 Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table:
@@ Line 36: / Line 51: @@
 The final weaved cable looks like this:
+{{::sw-rfd868-weaved-cable.jpg?600|}}
+You can remove the cable markings.
+==== Power Module to RFD868+ modem cable ====
+Stromversorgung zu PowerModule
+  * 4 mal 8" vorgekrimpt auf JST
+  * JST 4-polig auf Buchsenleiste 8-polig
+  * GND + GND, 5V + 5V (doppelte Kabel)
+{{ ::powermodule-pinlayout_5v.jpg?direct |}}
+Zur Kennzeichnung kann z.B. 10mm Schrumpfschlauch verwendet werden.