Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
searchwing-rfd868-mount [2020/02/16 13:35] beckmanf added safety pin and weaved cable |
searchwing-rfd868-mount [2020/02/17 12:43] j0ge4622 |
||
---|---|---|---|
Line 1: | Line 1: | ||
===== RFD 868+ telemetry radio mount ===== | ===== RFD 868+ telemetry radio mount ===== | ||
+ | |||
+ | Author: Friedrich Beckmann | ||
The modem is connected to the PixRacer Telem2 port and the power module. The modem is mounted in the right fuselage half and will be connected just shortly before glueing the two fuselage parts to the PixRacer and the Powermodule. | The modem is connected to the PixRacer Telem2 port and the power module. The modem is mounted in the right fuselage half and will be connected just shortly before glueing the two fuselage parts to the PixRacer and the Powermodule. | ||
Line 27: | Line 29: | ||
{{::sw-telem-uart.jpg?600|}} | {{::sw-telem-uart.jpg?600|}} | ||
+ | |||
+ | Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]] | ||
+ | Please note the different directions of the connector/cables in the labeling. | ||
+ | |||
+ | Pin layout of the Pixracer | ||
+ | {{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 |}} | ||
+ | |||
+ | Pin layout to the RFD868+ | ||
+ | {{ :pixacer-pinlayout_telem1.jpg?direct&400 |}} | ||
Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | ||
Line 43: | Line 54: | ||
{{::sw-rfd868-weaved-cable.jpg?600|}} | {{::sw-rfd868-weaved-cable.jpg?600|}} | ||
+ | You can remove the cable markings. | ||
+ | ==== Power Module to RFD868+ modem cable ==== | ||
+ | * 4x 8" JST already crimped cable | ||
+ | * JST 4-pin to female connector 8-pin | ||
+ | * GND + GND, 5V + 5V (double cable) | ||
+ | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
+ | To mark the cable use colored shrink tube. |