Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
searchwing-rfd868-mount [2020/02/16 13:44] beckmanf remove cable markings |
searchwing-rfd868-mount [2020/02/17 12:43] j0ge4622 |
||
|---|---|---|---|
| Line 29: | Line 29: | ||
| {{::sw-telem-uart.jpg?600|}} | {{::sw-telem-uart.jpg?600|}} | ||
| + | |||
| + | Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]] | ||
| + | Please note the different directions of the connector/cables in the labeling. | ||
| + | |||
| + | Pin layout of the Pixracer | ||
| + | {{ ::pixacer-pinlayout_telem1_in.jpg?direct&600 |}} | ||
| + | |||
| + | Pin layout to the RFD868+ | ||
| + | {{ :pixacer-pinlayout_telem1.jpg?direct&400 |}} | ||
| Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | ||
| Line 48: | Line 57: | ||
| ==== Power Module to RFD868+ modem cable ==== | ==== Power Module to RFD868+ modem cable ==== | ||
| + | * 4x 8" JST already crimped cable | ||
| + | * JST 4-pin to female connector 8-pin | ||
| + | * GND + GND, 5V + 5V (double cable) | ||
| + | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
| - | t.b.d. | + | To mark the cable use colored shrink tube. |
| - | + | ||
| - | + | ||
| - | + | ||