Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
searchwing-rfd868-mount [2020/02/17 12:35] j0ge4622 |
searchwing-rfd868-mount [2020/02/17 12:43] j0ge4622 |
||
---|---|---|---|
Line 29: | Line 29: | ||
{{::sw-telem-uart.jpg?600|}} | {{::sw-telem-uart.jpg?600|}} | ||
+ | |||
+ | Pixracer pin layout: [[https://docs.px4.io/v1.9.0/assets/flight_controller/pixracer/grau_setup_pixracer_top.jpg]] | ||
+ | Please note the different directions of the connector/cables in the labeling. | ||
Pin layout of the Pixracer | Pin layout of the Pixracer | ||
Line 34: | Line 37: | ||
Pin layout to the RFD868+ | Pin layout to the RFD868+ | ||
- | {{ :pixacer-pinlayout_telem1.jpg?direct&600 |}} | + | {{ :pixacer-pinlayout_telem1.jpg?direct&400 |}} |
Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | Please remember to connect the RFD868+ TX to the PixRacer RX and vice versa. So according to the following table: | ||
Line 54: | Line 57: | ||
==== Power Module to RFD868+ modem cable ==== | ==== Power Module to RFD868+ modem cable ==== | ||
+ | * 4x 8" JST already crimped cable | ||
+ | * JST 4-pin to female connector 8-pin | ||
+ | * GND + GND, 5V + 5V (double cable) | ||
+ | {{ ::powermodule-pinlayout_5v.jpg?direct |}} | ||
- | t.b.d. | + | To mark the cable use colored shrink tube. |
- | + | ||
- | + | ||
- | + |