This is an old revision of the document!
Making the plane waterproof for landing in the water
Finding the right glue
I tried 3 different glues. The model we use (mini talon) is made with “EPU” expandend PU.
I tried:
* UHU POR - special glue for Styropor and similar foams. * UHU Plus - 5 min two component epoxy * Hot Glue (Patex)
The results:
UHU Plus
UHU Por
works well. good fixture and waterproof:
But - the glue has to be applied in the right way! It has to be thin and completely dry before putting the parts together:
Bust is to spread it equally with a (gloved) finger:
Hot Glue
Closing holes
The so glued model had some holes to fill / close. I used thin plexi-glas. Best way to glue them was hot glue, as it can also fill little holes or irregularities in thickness.
I used the same technique also on other parts.
Waterproof the Servos
there are 2 interesting articles on Instructables on this topic:
https://www.instructables.com/id/Water-proofing-a-Servo/ https://www.instructables.com/id/Waterproof-your-servo-motors/ (if you want to follow this one, dont forget the glitter on your finger nails)
1. Make the housing waterproof
2. Insert a O-Ring under the horn