Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
searchwing-wing-servo [2020/02/02 13:55] beckmanf [Wing servo connection] schrumpfschlauch 1,2 -> 1,6 |
searchwing-wing-servo [2020/02/02 16:09] beckmanf 1.2 -> 1.6 |
||
|---|---|---|---|
| Line 24: | Line 24: | ||
| * Cut 25mm of the transparent shrinking tube and put it on the cable | * Cut 25mm of the transparent shrinking tube and put it on the cable | ||
| * Separate the yellow, red and brown cable for about 5cm | * Separate the yellow, red and brown cable for about 5cm | ||
| - | * Add about 5mm of the 1.2mm shrinking tube to the red and the brown cable. | + | * Add about 5mm of the small shrinking tube to the red and the brown cable. |
| * Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking | * Move the shrinking tubes as far as possible from the solder spot to avoid accidental shrinking | ||
| * Remove the isolation for about 4mm and twist and tin the wires. | * Remove the isolation for about 4mm and twist and tin the wires. | ||
| Line 48: | Line 48: | ||
| The next image shows the small shrinking tubes moved over the solder connections. | The next image shows the small shrinking tubes moved over the solder connections. | ||
| - | {{:sw-m5-shrinking-tube.jpg?600|Socket with 1.2mm shrinking tubes}} | + | {{:sw-m5-shrinking-tube.jpg?600|Socket with shrinking tubes}} |
| * Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed. | * Now shrink the black shrinking tubes with a heat gun. With the Heinel EL 1910 E heat gun select temperature "3" with maximum air speed. | ||